Panasonic UF-9000 Service Manual page 294

Local Firmware Update Tool (Parallel /USB Port)
Note:
For USB Connected Unit (DP-2310/3010): Every time the machine finishes receiving a firmware
code file, the unit does the delete and rewrite of the firmware code and will return to Service
Mode again automatically. Set the unit back to USB Firmware Update after the machine returns
to Service Mode and continue the firmware update.
When the last firmware code file (PNL) is received, the unit will re-boot automatically and return
to standby. The unit doesn't boot automatically when you select an independent file and PNL
firmware wasn't transferred. Cycle the power Off-On and reset the unit if the firmware code file
transfer is finished and the unit returned to the Service Mode.
When the unit returns to standby, Plug and Play of the printer will popup. Click [Cancel] to close
the Printer Plug and Play window.
For USB Connected Unit (DP-180/190, UF-9000): Every time the machine finishes receiving a
firmware code file, the unit does the delete and rewrite of the firmware code and will return to
USB Firmware Update automatically and continue the firmware update.
When the last firmware code file (AutoBoot) is received, the unit will re-boot automatically and
return to standby. The unit doesn't boot automatically when you select an independent file. (The
display returns to "Update in Progress") Cycle the power Off-On to reset the unit if the firmware
code file transfer is finished and the display shows Completed.
When the unit returns to standby, Plug and Play of the printer will popup. Click [Cancel] to close
the Printer Plug and Play window.
For Parallel Connected Unit:
Every time the machine finishes receiving a firmware code file, the unit does the delete, rewrite
of the firmware code and then boot. Set the unit back to Parallel Firmware Update in Service
Mode after boot up, to continue the firmware update.
When the transfers of all the firmware files are
8
finished, click [Finish] to close the tool.
Page 14