Frequently Required Parameters - Siemens SINAMICS G120 Operating Instructions Manual

Introduction

2.4 Frequently required parameters

2.4 Frequently required parameters
Commonly used parameters
Table 2- 1 Switching to commissioning mode or restore the factory setting
Parameter Description
p0010 Commissioning parameters
0: Ready (factory setting)
1: Perform quick commissioning
3: Perform motor commissioning
5: Technological applications and units
15: Define number of data records
30: Factory setting - initiate restore factory settings
Table 2- 2 How to determine the firmware version of the Control Unit
Parameter Description
r0018 The firmware version is displayed:
Table 2- 3 How you select the command source and setpoint sources
Parameter Description
p0015 Parameter p0015 allows the setting of pre-defined I/O configurations. Further information is given in the
section: Selecting the interface assignments (Page 41).
Table 2- 4 This is how you parameterize the up and down ramps
Parameter Description
p1080 Minimum speed
0.00 [rpm] factory setting
p1082 Maximum speed
1500.000 [rpm] factory setting
p1120 Rampup time
10.00 [s]
p1121 Rampdown time
10.00 [s]
16
Operating Instructions, 01/2011, FW 4.4, A5E02999804A AB
SINAMICS G120C Inverter