Connecting The Telephone Line Cable And Power Cord - Panasonic DX-600 Service Manual

8.8.

Connecting the Telephone Line Cable and Power Cord

Power Cord
Plug one end of the power cord into an ordinary 3 prong AC outlet and the other end into the receptacle on
the rear of the machine.
Warning: This apparatus must be properly grounded through an ordinary 3 prong AC outlet.
Do not break off the earth (ground) prong to fit a 2 prong outlet.
External Telephone (Optional)
You can connect an additional standard
single line telephone to the machine. To
connect the telephone, break off the
protective tab on the TEL jack.
RJ-11C Telephone Jack
Telephone Line Cable
Plug one end of the telephone line cable into the "RJ-11C" telephone jack supplied by the telephone
company and the other end into the LINE jack on the left side of the machine.
Ethernet LAN Cable
Ethernet-Token-Ring Bridge
(Optional Order No. UE-204006)
10Base-T/100Base-TX Ethernet Hub
NOTE
Edition 1.0
Power Cord (Included)
Telephone Line Cable (Included)
Ethernet LAN (10Base-T/100Base-TX)
Cable (Not included)
1. Your machine uses little power and you should keep it ON at all times.
If the power is turned OFF for too long, the clock contents may be lost.
ACTIVITY Lamp
Blinks when there is data traffic on the LAN.
LAN Cable
(10Base-T/100Base-TX Cable)
Insert the plug until a click is heard.
(LAN Cable is not included with the product.)
Purchase a Category 5 Cable, compliant with
EIA/TIA 568-A-5 standard.
290
RJ-45 LAN Jack
(10Base-T/100Base-TX)
LINK Lamp
Illuminates when connected to the LAN. Lamp
will not turn ON if the LAN Cable is defective
(contains breaks).
DX-600/800
APR 2002