Roland XP-60 Owner's Manual page 63

Reverb Send Level: 1–127
EFX Output Assign: MIX
EFX Output Level: 1–127
EFX Chorus Send Level: 0
EFX Reverb Send Level: 0
Chorus Level: 1–127
Chorus Output Assign: MIX
Reverb Level: 1–127
Using parallel and series connections simultane-
ously:
Output Assign: EFX
Mix/EFX Send Level: 1–127
Chorus Send Level: 1–127
Reverb Send Level: 1–127
EFX Output Assign: MIX
EFX Output Level: 1–127
EFX Chorus Send Level: 1–127
EFX Reverb Send Level: 1–127
Chorus Level: 1–127
Chorus Output Assign: M+R
Reverb Level: 1–127
Sending unprocessed direct sound to the DIRECT
OUTPUT jack:
Output Assign: DIR
Sending sound through the EFX to the DIRECT
OUTPUT jack:
Output Assign: DIR
Mix/EFX Send Level: 1–127
EFX Output Assign: DIR
EFX Output Level: 1–127
...........................................................................................................
EFX Param display
EFX parameters that you can set differ by the type selected
using the EFX Type parameter. For details refer to "EFX
effect types (EFX Parameter)" (p.74).
[PATCH] [F6] (Effects) [F2] (EFX Prm)/[F3] (EFX Ctl)
Chapter 3. Creating your own sounds
EFX Control display
As with Tone parameters, you can also modify EFX parame-
ters using controllers. EFX parameters that can be controlled
are indicated in parentheses ( ). They will differ by the EFX
Type parameter (PATCH/Effects/General) settings. For
details refer to "EFX effect types (EFX Parameter)" (p.74).
...........................................................................................................
<Control Source>
Each Patch can have two controller assignments (EFX Ctrl
1–2), and you can assign the following controllers to Control
Source.
OFF: A controller will not be used.
SYS-CTRL1: System controller 1
SYS-CTRL2: System controller 2
MODULATION: Modulation (MIDI controller number 1)
BREATH: Breath (MIDI controller number 2)
FOOT: Foot (MIDI controller number 4)
VOLUME: Volume (MIDI controller number 7)
PAN: Pan (MIDI controller number 10)
EXPRESSION: Expression (MIDI controller number 11)
PITCH BEND: Pitch bend
AFTERTOUCH: Aftertouch
If you want to use a controller that is common to all
Patches, or to use a controller that is not available for
selection here, first select SYS-CTRL1 or SYS-CTRL2
for Control Source, then use the Sys-Ctrl1 parameter
(SYSTEM/Control/Control Assign) or Sys-Ctrl2 para-
meter (SYSTEM/Control/Control Assign) to select the
controller.
...........................................................................................................
...........................................................................................................
<Depth>
Adjusts the degree of EFX parameter changes to occur in
response to controller movement. Higher values will result
in more change. Negative (-) values will invert the change
direction.
...........................................................................................................
...........................................................................................................
<Peak&Hold>
Pedal messages conventionally hold only note messages–
not effects settings. This makes it impossible to hold effects
settings as you play the phrase.
The XP-80 can hold parameter value changes (maximum
change value) even when the controller is returned to its
original position after receiving pedal messages.
...........................................................................................................
63