Roland XP-60 Owner's Manual page 107

...........................................................................................................
<Settings for Recording Quantize>
When you use quantization at recording, set parameters in
the Recording Quantize window. To open the Recording
Quantize window, press [F4] (Quantize).
Recording Quantize setting will be retained until it is
reset next time.
Type (Quantize type)
OFF: Quantization will not be applied to recording.
GRID: Grid quantization will be applied to recording.
SHUFFLE: Shuffle quantization will be applied to recording.
Resolution
Specifies quantization time interval as a note value.
For Grid Quantize available choices are
, and .
3
For Shuffle Quantize you can choose either
Strength (Grid quantize strength)
This parameter is used when Grid Quantize is selected. It
specifies how much the notes will move (correct) toward the
timing intervals specified by the Resolution parameter. If
you want notes to be move all the way to the nearest unit of
the specified Resolution for maximum quantization, set
Strength to 100%. As this value lowers, notes will move (cor-
rect) less from their original timing. With a setting of 0%, the
note locations will not change at all.
Rate (Shuffle quantize rate)
This parameter is used when Shuffle Quantize is selected. It
specifies how far a down-beat specified by the Resolution
parameter will be separated from the following up-beat.
With a setting of 50%, the timing of the up-beat note will be
at the exact mid point between the down-beat and the fol-
lowing down-beat. With a setting of 0%, the up-beat note
will move to the same timing as the previous down-beat.
With a setting of 100%, it will move to the same timing as
the following down-beat.
Count In
Specifies the way in which recording will begin.
0: Recording will begin immediately when you press
[STOP/PLAY].
1: When you press [STOP/PLAY], a 1-measure count (play-
back) will be included just before recording start position,
and recording will commence when the start position is
reached.
2: When you press [STOP/PLAY], a 2-measure count (play-
back) will be included before recording start position, and
recording will commence when the start position is reached.
, , ,
3
3
or .
Chapter 4. Playing back and recording a song
Wait Note: Recording will begin when you play a note or
press the Hold pedal.
TRK (Recording track)
Selects the recording destination Phrase track or Pattern. The
cursor will move to the selected recording destination
Phrase track.
Phrase tracks containing sequencer data will be marked with
"o" on the display and Phrase tracks without sequencer data
with "-." Phrase tracks that contain sequencer data but are
not to play back will be displayed in grey.
When recording Patterns, nothing will be displayed here.
PART
Selects the Part to use for recording.
When recording a Part with the number corresponding to
the Phrase track's, selecting a Phrase track will also select the
correspondingly numbered Part. There is no need to select a
Part here.
Use this parameter when you want to record using a Part
with a number different from the Phrase track's or recording
your performance in a Pattern.
If you've selected Patch mode or Rhythm Set mode,
"Patch Mode" or "Rhythm Set Mode" will be dis-
, ,
played instead of "PART."
If a Layer Performance has been selected, Parts indicat-
ed with "o" (Local Switch parameter set ON) will be
recorded as you press the key.
Patch/Rhythm Set
The name of the Patch or Rhythm Set assigned to the current
Part will be displayed in parentheses (
Patch or Rhythm Set, modify the group and number. This
process also applies for recording in Patch mode or Rhythm
Set mode.
). To change the
107