Roland XP-60 Owner's Manual page 215

Expression (Controller number 11)
status 2nd byte 3rd byte
BnH 0BH vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=Expression : 00H - 7FH (0 - 127)
* If the Volume parameter (SYSTEM/Control/Control Source) is set to
VOL&EXP, the volume of the Part corresponding to the MIDI channel of the
received message will be adjusted. However this is not received if the
Volume parameter (PATCH/LFO&Ctl/Control Switch) is OFF.
* In GM mode, the volume can always be controlled.
Hold 1 (Controller number 64)
status 2nd byte 3rd byte
BnH 40H vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 7FH (0 - 127) 0-63=OFF, 64-127=ON
* Not received when the Hold-1 parameter (PATCH/LFO&Ctl/Control Switch)
is OFF.
Portamento (Controller number 65)
status 2nd byte 3rd byte
BnH 41H vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 7FH (0 - 127) 0-63=OFF, 64-127=ON
* The Switch parameter (PATCH/Common/Common Control) will change.
Sostenuto (Controller number 66)
status 2nd byte 3rd byte
BnH 42H vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 7FH (0 - 127) 0-63=OFF, 64-127=ON
Soft (Controller number 67)
status 2nd byte 3rd byte
BnH 43H vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 7FH (0 - 127) 0-63=OFF, 64-127=ON
Hold 2 (Controller number 69)
status 2nd byte 3rd byte
BnH 45H vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 7FH (0 - 127)
Sound Controller 2 (Controller number 71)
status 2nd byte 3rd byte
BnH 47H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
* The Resonance parameter (PATCH/TVF/TVF Param) will change relative-
ly.
Sound Controller 3 (Controller number 72)
status 2nd byte 3rd byte
BnH 48H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
* The Time 2—4 parameter (PATCH/TVF/TVF Envelope) , The Time 2—4
parameter (PATCH/TVA/TVA Envelope)will change relatively.
Sound Controller 4 (Controller number 73)
status 2nd byte 3rd byte
BnH 49H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
* The Time 1 parameter (PATCH/TVF/TVF Envelope) , The Time 1 parame-
ter (PATCH/TVA/TVA Envelope)will change relatively.
Sound Controller 5 (Controller number 74)
status 2nd byte 3rd byte
BnH 4AH kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-64 - 0 - +63)
* The Cutoff Frequency parameter (PATCH /TVF/TVF Param) will change
relatively.
Chapter 12. Supplementary material
General Purpose Controller 5 (Controller number 80)
status 2nd byte 3rd byte
BnH 50H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
* The Level 1 — 3 parameter (PATCH/TVA/TVA Param) of Tone 1 will
change relatively.
General Purpose Controller 6 (Controller number 81)
status 2nd byte 3rd byte
BnH 51H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
* The Level 1 — 3 parameter (PATCH/TVA/TVA Param) of Tone 2 will
change relatively.
General Purpose Controller 7 (Controller number 82)
status 2nd byte 3rd byte
BnH 52H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
* The Level 1 — 3 parameter (PATCH/TVA/TVA Param) of Tone 3 will
change relatively.
General Purpose Controller 8 (Controller number 83)
status 2nd byte 3rd byte
BnH 53H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=control value : 00H - 40H - 7FH (-128 - 0 - +126)
* The Level 1 — 3 parameter (PATCH/TVA/TVA Param) of Tone 4 will
change relatively.
Portamento Control
status 2nd byte 3rd byte
BnH 54H kkH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
kk=source note number : 00H - 7FH (0 - 127)
* A Note On message received immediately after a Portamento control will
be sounded with the pitch changing smoothly from the source note number.
If a voice is already sounding at the same note number as the source note
number, that voice will change pitch to the pitch of the newly received Note
On, and continue sounding (i.e., will be played legato).
* The speed of the pitch change caused by Portamento is determined by the
Time parameter (PATCH/Common/Common Control) value.
Effect 1 (Reverb Send Level) (Controller number 91)
status 2nd byte 3rd byte
BnH 5BH vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=Reverb Send Level : 00H - 7FH (0 - 127)
* Not received in Patch mode.
Effect 3 (Chorus Send Level) (Controller number 93)
status 2nd byte 3rd byte
BnH 5DH vvH
n=MIDI channel number : 0H - FH (ch.1 - ch.16)
vv=Chorus Send Level : 00H - 7FH (0 - 127)
* Not received in Patch mode.
(Controller number 84)
215