Siemens Insys 56k Operating Manual page 66

S- Registry
S24* Sleep Timer
The time after which the modem switches to energy saving mode (sleep) during
inactivity is determined (in seconds) in S24. The energy saving mode will be quit
as soon as characters are sent to the modem, or when a call comes in.
Note:
S25 Time period for DTR signal
Time period, in which a DTR signal is applied to the modem before it hangs up (in
hundreds of seconds).
S26
Time period between RTS/CTS
Time period between RTS and CTS activation in 1/100 seconds.
S27* General settings
Bit
Bit 0-3
Bit 4.5
Bit 6
Bit 7
S29
Time period for modifier "flash"
Sets the time period in tenths of seconds, after which the modem hangs up due to
a flash in the dialing string.
S30 Time period until hang up due to silence
Time period, in which the modem waits without activity before hanging up. Units
in seconds (only for FAX Class 1).
60
When the modem is in sleep mode, it is necessary to send an "AT"
command before sending other commands. This first "AT"
command may not be answered with "OK". Further AT commands
may be entered immediately.
Meaning
RS232-Mode
Reserved
CCITT or Bell
Modulation
Asynchronous Mode Selection:
0: see AT&M0 or AT&Q0
9: see AT&Q5
10: see AT&Q6
CCITT/Bell Select
0: CCITT Modulation
1: Bell Modulation
Remote control
0: Remote control off
1: Remote control on
Pocket Modem 56k
Dezember 05