Siemens Insys 56k Operating Manual page 64

S- Registry
S13* Number of dialing attempts to send the message
Bit
Bit 0-3
Bit 4-7
S14* General settings
Bit
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
S15* DTC Time Settings
The idle connection control is a function integrated in the firmware which
monitors the data transmission in online mode. This function prevents the
modem to stay online for an unlimited amount of time, although no data is being
transmitted anymore.
In the registry S15, any time period between 1 and 255 seconds may be entered. If
S15 is set to 0, the idle connection control is switched off.
The timer will run immediately after the modem goes off-hook. As soon as the
timer has run out, a modem reset is performed (which will forcibly lead to the
hanging up of the modem).
S17* Initial character for remote configuration
In S17, the ASCII code of a character which is used to start the remote
configuration, is defined. Values >127 switch the remote configuration off
completely. The default setting in S17 is "42", which equals the ASCII character
"*". This means that the remote configuration is started with the Escape character
sequence
<Pause> **** <Pause>.
Note: The number of characters in the Escape sequence is fixed to "4" characters.
58
Meaning
Number of dialing attempts
Reserved
Meaning
Reserved
Echo on inputs
Reserved
Result format
Reserved
Tone/pulse dialing
Reserved
Originate/answer
Range of values: 1...12
Default value: 3
S13 determines the number of attempts to send the
message.
Note:
The limitation to a maximum of 12
attempts is necessary for approval
purposes (black listing).
Command echo 0: Echo off
1: Echo on
Result codes: 0: Message numbers (ATV0)
1: Message texts (ATV1)
Tone/pulse 0: Tone dialing (ATT)
1: Pulse dialing (ATP)
Originate/answer 0: Answer mode
1: Originate mode
Pocket Modem 56k
Dezember 05