Siemens Insys 56k Operating Manual page 55

Pocket Modem 56k
Command
AT+VCID=<n>
AT+VRID=<n>
ATW<n>
AT&W<n>
Dezember 05
Description
Set CLIP
With this function, the phone number of the caller can be displayed during an incoming
call.
(Only for phone lines or systems that support CLIP. If you want to use the CLIP function,
please ask your network provider, if your connection supports this function.
The following countries support CLIP:
Australia, Belgium, China, Denmark, Germany, Finland, Great Britain, Hong Kong, India,
Ireland, Iceland, Italy, Canada, Korea, New Zealand, The Netherlands, Norway, Austria,
Sweden, Singapore, Spain, Taiwan, USA).
Switches the CLIP function off (default).
AT+VCID=0
Switches the CLIP function on and displays the ID preformatted for
AT+VCID=1
incoming calls.
Switches the CLIP function on and displays the ID unformatted for
AT+VCID=2
incoming calls.
Set last received CLIP
The command AT+VRID displays the CLIP of the last caller.
Displays the ID preformatted.
AT+VRID=0
Displays the ID unformatted.
AT+VRID=1
Error correction messages
This command determines which data transmission rate information is provided for a
CONNECT message.
The modem reports the baud rate between modem and PC (default).
ATW0
During the connection setup, the modem reports the phone line speed,
ATW1
the error correction protocol and the PC baud rate.
The modem reports the phone line speed.
ATW2
Save configuration
The command saves the current modem configuration including the S registry in one of
the two user-defined defaults.
Save in user default 0
AT&W0
Save in user default 1
AT&W1
AT commands
49