Siemens Insys 56k Operating Manual page 53

Pocket Modem 56k
Command
AT\V<n>
AT*V
AT*V?
AT*V<n>
AT*V<n>?
Dezember 05
Description
Format of connect rate messages
This command enables the display of the connect message in three lines
AT\V0
This command enables the display of the connect message in one line
AT\V1
(default)
Definition of the common alarm texts (collective message)
for simple alarm: Definition of the alarm text (maximum of 160 characters)
for pulse alarm: Definition of the common part of the alarm message (maximum of
160 characters – within HSComm limited to 120 characters)
To the input AT*V the modem responds with NEW TEXT: and expects the input of the
alarm text (completed with <CR>)
This command is not available in the remote operation mode.
Relevant commands: AT*V, AT*V<n>
AT*Z0
Query of the common alarm texts (collective message)
The common part of the alarm message is queried with the command AT*V?.
Definition of the variable alarm texts and phone numbers
Definition of the alarm texts and phone numbers to send SMS, at input 1 or 2.
After the input AT*V1 or AT*V2 the modem responds with NEW TEXT: and expects
an input in the format phone number,message<CR>
Enter without characters for accessing the exchange (only
Phone number
required for service number)
Alarm message (maximum of 80 characters)
Message
For the transmission, the variable part (maximum of 80 characters) will be attached to
the common part (maximum of 160 characters) of the collective message. Of the
maximum of 240 characters, the first 160 characters are sent as SMS.
This command is not available in the remote operation mode.
Relevant commands: AT*V<n>
AT*Z0
Query of the variable alarm texts and phone numbers
The variable part of the alarm message and the target phone number are queried with
AT*V1? or AT*V2?.
Definition of messages/phone numbers
Definition of the SMS service center
Definition of messages/phone numbers
Definition of the SMS service center
AT commands
47