Suzuki GZ250 Marauder Service Manual page 93

• Install the clutch sleeve hub and lock washer.
• Install the clutch sleeve hub nut, and tighten it to the
specified torque using the special tool.
09920-53740: Clutch sleeve hub holder
Clutch sleeve hub nut: 50 N-m (5.0 kg-m, 36.0 Ib-ft)
• Bend the lock washer securely.
• Install the washer seat
shown.
• Install the clutch drive plate No.2
• Install the clutch drive plates No.1
one by one into the clutch sleeve hub.
• Install the clutch push rod
• Install the push piece , bearing and washer
• Install the clutch pressure plate
clutch spring mounting bolts.
• Hold the generator rotor using the special tool and tight-
en the clutch spring mounting bolts to the specified
torque in a crisscross pattern.
09930-44913: Rotor holder
Clutch spring mounting bolt:
10N-m(1.0kg-m, 7.0 Ib-ft)
NOTE:
Make sure that the clutch pressure plate is installed cor-
rectly.
• Loosen the lock nut , and turn in the release screw
to feel resistance.
• From that position, turn out the release screw
and tighten the lock nut
Downloaded from www.Manualslib.com
and spring washer
by holding the release screw
manuals search engine
as
and driven plates
, clutch springs and
turn,
ENGINE 3-56