Suzuki GZ250 Marauder Service Manual page 7

CAUTION
* If parts replacement is necessary, replace the parts with Suzuki Genuine Parts or their
* When removing parts that are to be reused, keep them arranged in an orderly manner
* Be sure to use special tools when instructed.
* Make sure that all parts used in reassembly are clean. Lubricate them when specified.
* Use the specified lubricant, bond, or sealant.
* When removing the battery, disconnect the negative cable first and then the positive
cable.
* When reconnecting the battery, connect the positive cable first and then the negative
cable, and cover the positive terminal with the terminal cover.
* When performing service to electrical parts, disconnect the battery negative cable un less
the service procedure requires the battery power.
* When tightening cylinder head and crankcase bolts and nuts, tighten the larger sizes
first. Always tighten the bolts and nuts from the inside working out, in a crisscross
pattern and to the specified tightening torque.
* Whenever you remove oil seals, gaskets, packing, O-rings, self-locking nuts, locking
washers, cotter pins, circlips, and certain other parts as specified, be sure to replace them
with new ones. Also, before installing these new parts, be sure to remove any left over
material from the mating surfaces.
* Never reuse a circlip. When installing a new circlip, take care not to expand the end gap
larger than required to slip the circlip over the shaft. After installing a circlip, always ensure
that it is completely seated in its groove and securely fitted.
* Use a torque wrench to tighten fasteners to the specified torque. Wipe off grease and
oil if a thread is smeared with them.
* After reassembling, check parts for tightness and proper operation.
CAUTION
Downloaded from www.Manualslib.com
equivalent.
so that they may be reinstalled in the proper order.
manuals search engine
GENERAL INFORMATION 1-2