Side-Stand/Ignition Interlock System Part Inspection - Suzuki GZ250 Marauder Service Manual

6-15 ELECTRICA L SY STEM
Measure the starter relay resistance between the terminals
( and
Starter relay resistance: 3-6
SIDE-STAND/IGNITION INTERLOCK
SYSTEM PART INSPECTION
If the interlock system does not operate properly, check
each component. If any abnormality is found, replace the
component with a new one.
NEUTRAL SWITCH
The neutral switch coupler is located under the fuel tank.
• Remove the front seat. (See p. 5-1.)
• Remove the fuel tank. (See p. 4-1.)
• Disconnect the neutral switch coupler and measure the
continuity between Blue and Ground with the transmis-
sion in neutral.
ON (in neutral)
OFF (not in neutral)
SIDE-STAND SWITCH
The side-stand switch coupler is located under the fuel
tank.
• Remove the front seat. (See p. 5-1.)
• Remove the fuel tank. (See p. 4-1.)
• Disconnect the side-stand switch lead wire coupler and
measure the voltage between Green and Black/White
lead wires.
09900-25008: Multi circuit tester set Tester
knob indication: Diode test (
right position)
OFF
(DOW N position)
NOTE:
If the tester read under 1.4V, replace the battery of multi
circuit tester when do not connecting the tester probes.
Downloaded from www.Manualslib.com
).
Blue
Green
( Probe)
ON (UP-
manuals search engine
Ground
)
Black/White
( Probe)
0.4-0. 6 V
1.4-1. 5 V