Suzuki GZ250 Marauder Service Manual page 144

NOTE:
When installing the front turn signal lights, insert the projec-
tion on the turn signal light bracket into the hole of steering
stem upper bracket.
• Install the handlebar left switch.
NOTE:
Insert the projection into the hole of the handlebars.
* Install the handlebar right switch.
NOTE:
* Apply SUZUKI SUPER GREASE "A" to the end of the
throttle cable.
* Insert the projection
• Install the master cylinder. (See p. 5-13.)
• Install the front brake caliper. (See p. 5-10.)
• Install the front fender and front wheel. (See pp. 5-6 and
-21.)
NOTE:
Hold the front fork legs, move them back and forth and
make sure that the steering is not loose.
A CAUTION
After performing the adjustment and installing the
handlebars, "rock" the front wheel assembly for-
ward and backward to ensure that there is no play
and that the procedure was accomplished correct-
ly. Finally, check to make sure that the steering
stem moves freely from left to right with its own
weight. If play or stiffeness is noticeable, re-adjust
the steering stem nut.
Downloaded from www.Manualslib.com
99000-25010: SUZUKI SUPER GREASE "A"
into the hole of the handlebars.
manuals search engine
CHASSIS 5-28