Backfeed Distance - Paxar 9855 Operator's Handbook Manual

B a c k f e e d D i s t a n c e
This is the amount to move the label backwards. The backfeed
distance can not be greater than the dispense position. If you
make the backfeed distance greater than the dispense position,
the dispense position automatically changes to match the

backfeed distance.

The backfeed distance should equal the dispense position. An
exception is when you are tearing labels, instead of peeling.
Then, the backfeed distance must be 30 dots (0.15 inches) less
than the dispense position to account for improper tearing of butt
cut supplies. You will have a 30-dot non-print zone on your
supply, but this prevents exposed adhesive under the printhead.
To change the setting, from the Main Menu, select Setup, Supply,
then Positioning. Follow these steps.
1. Press l or r until you see
2. Press Enter/Pause.
3. Press l or r to change the dispense position. Pressing l
decreases the value; r increases it.
4. Press Enter/Pause when the number you need appears.
Press Escape/Clear until you see the Main menu.
POSITIONING
l
Backfeed Dis
BACKFEED DIS
[10/200]: +65
Setting Supply Options 4-13