Table of Contents
Advertisement
2
Slide the switch into the rack. Insert and tighten the rack-mount screws.
Caution: Do not set a BayStack 10 Power Supply Unit on top of a Ethernet Routing
Switch 3510-24T. The BayStack 10 Power Supply weighs approximately 100 pounds (45
kg), and the switch housing is not strong enough to support this weight. (For translations
of this statement, see
Cabling requirements for the Ethernet Routing Switch 3510-24T
Required cables:
10/100/1000BASE-T
ports:
Console Port:
Shared SFP GBIC ports:
page
31.)
Description
Category 5 UTP cable with an RJ-45 connector
Serial cable with DB-9 female connector on one end for use with included
gender changer, or a serial cable with DB-9 male connector on one end.
Note: The maximum length for the console port cabling is 25 feet (8.3 m).
Varies with the installed SFP GBIC; refer to the documentation that was
shipped with the SFP GBIC for specifications.
Installing the Ethernet Routing Switch 3510-24T
17
Hide quick links:
Advertisement
Table of Contents
