Table Of Contents - Nortel 3510-24T Installing Manual

12
Installing the Ethernet Routing Switch 3510-24T
The following section describes the installation instruction for the Ethernet Routing Switch
3510-24T.
This section covers the following topics:
• "Environmental requirements for the Ethernet Routing Switch
• "Package contents for the Ethernet Routing Switch 3510-24T" on page 13
• "Installing the Ethernet Routing Switch 3510-24T on a table or shelf" on page 14
• "Installing the Ethernet Routing Switch 3510-24T in an equipment rack" on page 16
• "Cabling requirements for the Ethernet Routing Switch 3510-24T" on page 17
• "RJ-45 connector pin assignments" on page 19
• "Console port pin assignments" on page 20
• "Connecting AC power" on page 21
• "Power specifications for the Ethernet Routing Switch 3510-24T" on page 22
• "Checking LEDs on the Ethernet Routing Switch 3510-24T" on page 23
• "Setting IP parameters for the Ethernet Routing Switch 3510-24T" on page 25
Environmental requirements for the Ethernet Routing Switch
3510-24T
Make sure that the area where you install and use the Ethernet Routing Switch 3510-24T meets the
following environmental requirements:
• Ambient temperature between 32
• Relative humidity between 5% and 95% noncondensing
• No heat sources nearby such as hot air vents or direct sunlight
• No sources of severe electromagnetic noise nearby
• No excessive dust
• Adequate power source within six feet
• At least 2 inches (5.08 cm) on each side of the switch unit for ventilation.
217326-A
and 104 F (0 and 40
° ° °
3510-24T", next
C)
°