Nortel 3510-24T Installing Manual page 24

24
Table 5 Switch LEDs on the Ethernet Routing Switch 3510-24T
Label Status
Power On
Off
Status Steady
Blinking
Off
Table 6 10/100/1000 and Shared GBIC Port LEDs on the Ethernet Routing Switch 3510-24T
Label Color/Status
1000 On
Off
LNK/ACT Steady
Blinking
Slow blinking
Off
Note: The GBIC ports are shared. When a GBIC is inserted, the corresponding front
panel port is inactive.
For more information on shared ports, refer to Using the Ethernet Routing Switch
3510-24T.
217326-A
Meaning
The switch is connected to AC power and is receiving power.
The switch is not connected to AC power, or the AC power is not supplying
power.
The power-on self test is complete, and the switch is operating normally.
A nonfatal error occurred during the self-test.
The switch failed the self-test.
Description
This port is set to operate at 1000 Mbps.
This port is set to operate at 10 or 100 Mbps (and LNK/ACT LED is green).
When this LED is Off, refer to the LNK/ACT LED section.
The link is good.
There is activity on this port. The blinking rate indicates the level of activity.
This port has been disabled by software.
This port is has no link nor activity.