Hach Anatel PAT700 User Manual page 124

Alarms
Code Message
103 IncorrectBottleLoadedinPosition4
104 NotEnoughFluidinBottle1
105 NotEnoughFluidinBottle2
106 NotEnoughFluidinBottle3
107 NotEnoughFluidinBottle4
118 UnableToChangeLanguageSettings
119 UnableToReadLanguageSettings
120 UnableToChangeEthernetSettings
121 UnableToReadEthernetSettings
122 UnableToPrintSystemSettings
125 UnableToStartLampTest
126 UnableToStopLampTest
127 UvLampLifeExceeded
129 UnableToReadInformationFromBottle
130 UnableToWriteInformationToBottle
131 UnableToStart4to20mAOutputs
132 UnableToStartPumpTest
133 UnableToStopPumpTest
134 UnableToCalibratePump
135 UnableToExportDataLog
136 UnableToExportAuditTrail
137 UnableToAddUser
138 UnableToEditUser
139 UnableToDeleteUser
141 UnableToAcknowledgeAlarms
142 UnableToDeleteAlarms
143 UnableToStartSelfClean
144 UnableToStopSelfClean
145 UnableToStartOnlineManualSample
146 UnableToStopOnlineManualSample
147 UnableToRestoreFactoryDefaults
148 UnableToStartVoltageTest
Page 122
Table 16 Warning alarm messages
Alarm condition
• Incorrect bottle detected in position 4.
• Analyzer cannot perform bottle test operation.
• Not enough fluid in bottle 1 to complete operation.
• Check bottle 1 before starting operation.
• Analyzer aborts operation and returns to its normal operating
mode.
• Not enough fluid in bottle 2 to complete operation.
• Check bottle 2 before starting operation.
• Analyzer aborts operation and returns to its normal operating
mode.
• Not enough fluid in bottle 3 to complete operation.
• Check bottle 3 before starting operation.
• Analyzer aborts operation and returns to its normal operating
mode.
• Not enough fluid in bottle 4 to complete operation.
• Check bottle 4 before starting operation.
• Analyzer aborts operation and returns to its normal operating
mode.
Analyzer cannot change language settings.
Analyzer cannot read language settings
Analyzer cannot change Ethernet settings.
Analyzer cannot read Ethernet settings.
Analyzer cannot print system settings.
Analyzer cannot start lamp test.
Analyzer cannot stop lamp test.
• Lamp hours of usage have been exceeded or UV Detect™
output has dropped below acceptable limit.
• Lamp has been set to a status of marginal.
• Replace lamp.
Analyzer cannot read information from bottle.
Analyzer cannot write information to bottle.
Analyzer cannot start 4-20 mA output test.
Analyzer cannot start pump test.
Analyzer cannot stop pump test.
Analyzer cannot calibrate pump.
Analyzer cannot export data log.
Analyzer cannot export audit trail.
Analyzer cannot add a user.
Analyzer cannot edit a user.
Analyzer cannot edit a user.
Analyzer cannot acknowledge alarm.
Analyzer cannot delete alarms.
Analyzer cannot start self clean.
Analyzer cannot stop self clean.
Analyzer cannot start online manual sample.
Analyzer cannot stop online manual sample.
Analyzer cannot restore factory defaults.
Analyzer cannot start voltage test.