LPU
FIP-110
FIP-110 front panel
Figure 73 FIP-110 front panel
(1) Slot 4
(3) Combo interface 1
(5) Slot 1
(7) OPEN BOOK mark
FIP-110 specifications
Item
Memory type and size
NVRAM
Combo interface
HIM
MIM
Hardware encryption
Hot swapping
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the
copper port or the fiber port. To switch between the copper and fiber ports, use the combo
enable { copper | fiber } command in interface view. For more information about the combo
enable { copper | fiber } command, see HPE FlexNetwork HSR6800 Routers Interface
Command Reference.
• Use transceiver modules provided by Hewlett Packard Enterprise only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
Remarks
•
Default—Two 1-GB DDR2 SDRAMs
•
Maximum—Two 2-GB DDR2 SDRAMs
128 KB
2
2 copper ports
(MDI/MDIX autosensing)
2 fiber ports
Not supported
4
Supported
Supported
93
(2) Slot 3
(4) Combo interface 0
(6) Slot 2
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex