Fip-300 - HP FlexNetwork HSR6800 Installation Manual

FIP-240 specifications
Item
Memory type and size
NVRAM
Combo interface
MIM
HIM
Hardware encryption
Hot swapping
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the
copper port or the fiber port. To switch between the copper and fiber ports, use the combo
enable { copper | fiber } command in interface view. For more information about the combo
enable { copper | fiber } command, see HPE FlexNetwork HSR6800 Routers Interface
Command Reference.
• Use transceiver modules provided by Hewlett Packard Enterprise only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
FIP-240 combo interface specifications
Specification of combo interfaces on the FIP-240 and the FIP-110 are the same. For more
information, see
Transceiver modules available for the FIP-240 fiber ports are the same. For more information,
see Table 44.
Maximum interface modules provided by FIP-240 in full configuration
FIP/Interface
module
FIP-240
MIM
HIM

FIP-300

The FIP-300 supports HIMs and MIMs, and it provides 12 combo interfaces.
Remarks
•
Default—One 2-GB DDR3 SDRAM
•
Maximum—Two 2-GB DDR3 SDRAMs
128 KB
2
2 copper ports (MDI/MDIX
autosensing)
2 fiber ports
4 supported
2 full-height or 4 half-height HIMs supported
(Half-height HIMs include HIM-4G4P, HIM-TS8P, and HIM-8GBP-V2.)
Supported
Supported
Table 42 and Table 43.
HSR6802
2
8
4 (8 half-height HIMs)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex
HSR6804
4
16
8 (16 half-height HIMs)
97
HSR6808
8
32
16 (32 half-height HIMs)