103; Fip-600 - HP FlexNetwork HSR6800 Installation Manual

FIP-600

FIP-600 front panel
Figure 78 FIP-600 front panel
(1) Combo interface 1
(3) Slot 1
(5) OPEN BOOK mark
FIP-600 specifications
Item
Memory type and size
NVRAM
Combo interface
HIM
MIM
Hardware encryption
Hot swapping
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the
copper port or the fiber port. To switch between the copper and fiber ports, use the combo
enable { copper | fiber } command in interface view. For more information about the combo
enable { copper | fiber } command, see HPE FlexNetwork HSR6800 Routers Interface
Command Reference.
• Use transceiver modules provided by Hewlett Packard Enterprise only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
FIP-600 combo interface specifications
Specification of combo interfaces on the FIP-600 and the FIP-110 are the same. For more
information, see
Remarks
•
Default—Two 2-GB DDR3 SDRAMs
•
Maximum—Two 2-GB DDR3 SDRAMs
128 KB
2
2 copper ports
(MDI/MDIX autosensing)
2 fiber ports
2 supported
Not supported
Supported
Supported
Table 43.
Table 42 and
(2) Combo interface 0
(4) Slot 2
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex

103