HP FlexNetwork HSR6800 Installation Manual page 104

FIP-300 front panel
Figure 76 FIP-300 front panel
(1) HIM/MIM slot
(3) GE0 through GE11 fiber ports
FIP-300 specifications
Item
Memory type and size
NVRAM
Combo interface
HIM
MIM
Hardware encryption
Hot swapping
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the
copper port or the fiber port. To switch between the copper and fiber ports, use the combo
enable { copper | fiber } command in interface view. For more information about the combo
enable { copper | fiber } command, see HPE FlexNetwork HSR6800 Routers Interface
Command Reference.
• Use transceiver modules provided by Hewlett Packard Enterprise only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
FIP-300 combo interface specifications
Specification of combo interfaces on the FIP-300 is the same as FIP-110. For more information,
see Table 42
Table 45 Transceiver modules available for the FIP-300 fiber ports
Product
code
JD089B
Remarks
•
Default—Two 2-GB DDR3 SDRAMs
•
Maximum—Two 2-GB DDR3 SDRAMs
128 KB
12
Copper ports (MDI/MDIX
autosensing)
Fiber ports
1 supported
1 supported
Supported
Supported
and Table 43.
Central
Description
wavelength
HPE X120 1G
N/A
SFP RJ45 T
(2) GE0 through GE11 copper ports
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex
Connector
RJ-45
98
Max.
Optical fiber transmission
distance
Category 5 or
100 m (328.08 ft)
above twisted