Installing Your Interface Module(S) - Paradyne IP Broadband Loop Carrier 12000E Installation Instructions Manual

Installing Your Interface Module(s)

Interface modules provide the subscriber connections for an 12000E; up to twelve
interface modules may be installed in the 12000E (slots 1–12). There are a variety
of models available for purchase; contact your sales representative for further
information or visit www.paradyne.com for a list of available products. Any
combination of interface module models may be installed in an 12000E as long as
they are supported by the model type and version number of your management
module; refer to the Release Notes for your particular management module model
for compatibility information.
Procedure
IPD1-A2-GZ40-10
1. Select a slot for installation. Although the 12000E is factory shipped with Slot 1
open, interface modules may be installed in any slot, 1–12.
CAUTION:
If a slot cover is removed from slot 2–12, it must be replaced with an
interface module. DO NOT OPERATE YOUR 12000E WITH AN EMPTY
MODULE SLOT.
2. With the interface module PCB facing right and the interface module model
name upright, align the upper and lower edges of the PCB with the slot
module guides.
INTERFACE
MODULE
Slot Module Guides
July 2005
9