Introduction; Unpacking And Inspecting The Equipment - Paradyne IP Broadband Loop Carrier 12000E Installation Instructions Manual

10. This Agreement shall be governed by the laws of the State of Florida, without

Introduction

Paradyne's 12000E IP Broadband Loop Carrier (BLC) provides a high capacity
and native IP Ethernet foundation for a variety of feature-rich multi-service access
multiplexer modules.
The 12000E BLC is engineered for efficient, high-speed IP data transport in a
compact, fully fault-tolerant chassis. It features a high capacity backplane
delivering up to 48 Gbps throughput and providing a non-blocking architecture for
even the highest bandwidth broadband access technologies, such as ADSL2+.
The 12000E BLC supports single or dual redundant uplink, management, and
switching modules. In redundant mode, both modules can be connected to the
dual backplanes with redundant modular backhaul/uplink ports to support 10/100
Ethernet, GigE (Copper or fiber), T1/E1, and dual bonded T1/E1 uplink modules.
For flexibility of installation the 12000E has removable mounting brackets that can
be placed in increments of 1.45" up to 9.28" from the front of the chassis, allowing
for multiple installation options in either 19" or 23" equipment racks.

Unpacking and Inspecting the Equipment

The following components should be included in the shipping container:
IPD1-A2-GZ40-10
9. Upon such termination, the Licensee shall refrain from any further use of the
Software and destroy the original and all copies of the Software in the
possession of Licensee together with all documentation and related materials.
regard to its provisions concerning conflicts of laws.
HANDLING PRECAUTIONS FOR
!
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
1 – 12000E with 1 fan module and 12 slot covers
4 – Rubber Bumper Screws
2 – Rack Mount Brackets (either 19" or 23", as ordered)
10 – #6 Phillips Bracket Screws
8 – #10 Phillips Rack Screws
8 – #12 Phillips Rack Screws
July 2005
3