Table of Contents
Advertisement
12. In addition, if the equipment is to be used with telecommunications circuits,
13. The equipment is intended for installation in an environment that is free of dust
14. When installed in the final configuration, the product must comply with the
15. CLASS 1 LASER PRODUCT: This product has provisions for the customer to
22
take the following precautions:
— Never install telephone wiring during a lightning storm.
— Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
— Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
— Use caution when installing or modifying telephone lines.
— Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
— Do not use the telephone to report a gas leak in the vicinity of the leak.
and dirt.
applicable Safety Standards and regulatory requirements of the country in
which it is installed. If necessary, consult with the appropriate regulatory
agencies and inspection authorities to ensure compliance.
install a Class 1 laser transceiver, which provides optical coupling to the
telecommunication network. Once a Class 1 laser product is installed, the
equipment is to be considered to be a Class 1 Laser Product (Appareil à Laser
de Classe 1). The customer is responsible for selecting and installing the laser
transceiver and for insuring that the Class 1 AEL (Allowable Emission Limit)
per EN/IEC 60825 is not exceeded after the laser transponders have been
installed. Do not install laser products whose class rating is greater than 1.
Refer to all important safety instructions that accompanied the transceiver
prior to installation. Only laser Class 1 devices certified for use in the country
of installation by the cognizant agency are to be utilized in this product. Also,
laser warnings are to be provided in accordance with IEC 60825-1 and its
Amendments 1 and 2, as well as 21 CFR 1010 and 1040.10(g).
!
UNITED STATES – EMI NOTICE:
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
The authority to operate this equipment is conditioned by the
requirements that no modifications will be made to the equipment
unless the changes or modifications are expressly approved by
Paradyne Corporation.
July 2005
IPD1-A2-GZ40-10
Advertisement
Table of Contents
