Table of Contents
Advertisement
Installing Uplink Interface Modules (Optional)
An SMD2000-24E does not require installation of an Uplink Interface Module (UIM) for
operational purposes. A UIM offers additional upstream network ports to supplement the
two E1 uplink ports already provided. You may wish to install a UIM if your network
requires an Ethernet uplink connection or if you require an additional E1 or T1 backhaul.
The SMD2000-24E supports the following 1-port UIMs only:
UIM-E1
UIM-T1
UIM-10/100
C
:
AUTION
Disconnect all power sources from the SMD2000-24E before installing a UIM.
Procedure
To install a UIM:
Remove the Chassis Cover.
1.
flathead screws securing the SMD2000-24E chassis cover and set them aside.
Carefully lift off the chassis cover and set it aside.
Side
Top
Side
Using a Phillips Screwdriver, remove the eight
Rear
Bottom
5
Advertisement
Table of Contents
