Setting Up The Dbm Physical Interface; Setting Up Isdn Link Profiles - Paradyne FrameSaver SLV 9626 Installation Instructions Manual

Remote site configuration guidelines:
– Set up the ISDN DBM physical interface.
– Configure a Link Profile for the central site in the first link profile, called HQ_Site.
When Automatic Backup Configuration is enabled, a backup DLCI will be
created automatically on the first ISDN link for each DLCI discovered on the
network interface.
– Configure the remote unit to originate calls to the central site. (A BRI DBM is
already configured to originate calls.)
– Enable the Automatic Backup Configuration feature.
– Set the criteria by which automatic backup will take place.

Setting Up the DBM Physical Interface

1. Configure the DBM interface.
Main Menu
2. Minimally, set the following configuration options:
– Interface Status set to Enable.
– Originate or Answer set to Answer for a central site, and set to Originate for a
remote site.
Service Profile ID1 (SPID)
Local Phone Number 1
Service Profile ID2 (SPID)
Local Phone Number 2
3. Save the configuration and return to the ISDN menu.

Setting Up ISDN Link Profiles

1. Select Link Profiles, then New.
2. Set up the ISDN Link Profiles.
– Name for the destination entered (e.g., Tampa). The default setting is HQ_Site.
– Link Status set to Auto.
– Phone numbers entered:
Originating System
Outbound phone number.
Valid characters can include:
Numbers (0 – 9)
Special characters * and #
Spaces
Remember to include local dial-out numbers (i.e., 9, then the number).
3. Save the configuration.
Configuration ISDN Physical
Answering System
Inbound Calling ID1 and ID2. These
are the phone numbers of units that
calls will be accepted from.
Valid characters can include:
Numbers (0 – 9)
10