Frame Assembly Instructions; Table Of Contents - ParaBody 950 st Assembly Instructions Manual

Frame Assembly Instructions
Use t'his procedure to ossemble the frame of the PareBody 950ST
Step 1
A.
Loosely assemble the leg wei.~,ht stack bose (18) a.n,,d the press weight s~ack base (1) to the
(15) using two 1/2 x .3-1/2 bolts (91), four 1/2 washers (79), and two 1/2" nylock nuts (B2)
~ho~n. Apply two non-skid s~rips (61) fo the base as shown.
B.
Loosely assemble the front uprig~ (31) to the base (15) using two 1/2 x 3-1/2" bolts (91),
1/2' washers (79), and two 1/2 nylock nuts (82) as shown.
3"
/2"
C.
Loosely ~ssembe the re~r ~,prighf (21) fo the b~se (15) using one li2 x bolt (87),
w~shers (79), ~nd one 1/2 nyock nul (82) ~s shown.
ssembl: the fop boom (20) ~o fh~ front upright (31) using one 1/2 x 3" bolt (BT),
D. Log~ly a,
,';~ --- --- ~/2" nvlock nut {82), and to the rear uprigh~ (~1) using two 1/2 x
1/Z wesners k~~},_~,
u~ ~'~
"~-_.. ~.~ ~/~,, low height nylock nut ~84) ~s shown.
Tighten
~1 frame connections.
5