Leg Station Cable Assembly Instructions - ParaBody 950 st Assembly Instructions Manual

STEP 1
A.
Leg Sfatlon Cable Assembly Instructions
Use this procedure to assemble the leg station cable of the PARABODY g50 ST
Route the "loop" end of the leg cable (108) into the rear slot of the leg welght star< base (18)
behind the weight stack, and out through the slot near the leg station.
B. Securely attach th~,,"loop" end of the leg cable (108), to the cam on the leg curl/e>:fension (8),
using one 3/8 x bolt (97), two 3/8" washers (78), and one 3/8" nylock
C.
Secure the leg cable (108) and one 3-1/2" pulley (111) to the pulley flat on the leg frame
using one 3/8 x 2-1/,¢" b,olt (119), one 2-3/B 'L' bracket (75), three 3/8" washer:, (7B), one
spacer (120), and one 3/8' nylock nut (B3). (Note: The leg cable should be ro,,te,:l underneath
short leg of the 'L' bracket and over the top of the pulley. Also the 'L' bracket shc, uld be posffioned
af a 45 degree angle to function properly.)
g. Secure the leg ca,hie (108.) and two 3-1/2 !' pulleys (111) to the leg weight stack base (18) using
two 3/8 x 2-3/4' bolts (9-9), four 3/8" flange spacers (74), and two 3/8" nylock nuts (B3).
Loop cable under the pulley prior to inserting if into the slot.)
Secure the leg cable (108~ and one 3-1/2' pulley (111) fo
leg guide rod support (25) using one 3/8 x 2-3/4" bolt (99),
two 3/8" flange spac..ers (74), and one 3/8" nylock nut (83).
(Note: Loop the cable over the pulley prior to inserting it in
the slot.)
24