Slap 8
A.
Slide
two hinge tabs (73) onto the wolff sleeve (39) and securely
attach press seat pad (49)
The "hinge" part of the hinge tab
1"
two 3/B x
bolts (97), and two 3/B" washers (7B). (Note:
should face upward.)
B.
Slide the right
back pad angle (2)
and left
back pad angle (3)
onto the wolff
sleeve (39)
1"
attach
the press back pad (50)
using four 3/8
bol{s (97),
and four 3/8" ~rashers (TB).
C.
Insert
one 3/4 x 10-1/2"
shaft
(116)
into
the press base (13)
as shown.
E.
Secure the press support
tubes (40))~],ght
back pad angle (2)and
the left
back pod angle
two 1/2" nylock nuts (82).
using two 1/2
x
bolts (87),
four
flange bearings (69),
and
Secure nuts, then back off
1/4 turn.)
F.
Center
3/4
x 10-1/2"
shaft
(116)
and secure press suppoH tubes (40)
using two 5/16
x 3/B"
screws
G.
Apply one rubber bumber (56)
to the back of the press back pad (50)
where the pad comes
contact with the rear bolt.
10