Advertisement
812 INNER/OUTER THIGH MACHINE ASSEMBLY INSTRUCTIONS
:~i~:~.'..'~ii~i~s~.;.'~:'::~.!i~*i~i~;':;~.".-'~.~:~i~is~i
..'.:'.'N-;:~.k~.}~/:%is~i~s:::.....~N~N}~..".i~i~i!~.;:~t~i~
~i~il."..~.i~."..~
.............................................................................................................................................
[iii~iiiliii~
~!~ii~~i:i~!~
~~
~ i~: ~{i: ~f~?
:' :" :" :" :' :' :':::?:"
:" :" :" :::':i:::'
:':' :" :' :':~?~
~?::'!~
:':" :" ::J? x. :. :. :. :. :. :. :. :. :-~::.~
!::. :. :::'::ii?
:' :" ".~:"
:' ': )!':i:"
:" :::" :" :: '::::: :" ": ':':':':':'::.,'.~
?..~:'.:!:~:?:i::'?:i~
~ ~ ~:':"
1.
Insert two (2) 2 IN. SQ. COVER CAPS onto both ends of the RIgAR BASE TI~E as shown on drawing.
°
SECURELY assemble the REAR BASE TUBE to the BASE as shown on drawing, using two (2) 3/8
3 IN. BOLTS, four (4) 3/8 IN. WASt-[ERS, and two (2) 3/8 x 3 IN. LOCK NUTS.
Insert two (2) 2 LN. SQ. COVER CAPS onto both ends of the FRONT BASE TUBE, and one Ill)
2
SQ. END CAP imo the BASE, a.~ shown on drawing.
SECURELY assemble the FRONT BASE TUBE to the BASE as shown on drawing, using two (2) 3/8
X 3 IN. BOLTS, four (4) 3/8 IN. WASHERS, and two (2) 3/8 x 3 IN. LOCI(
Attach eight (8) PAKAGLIDE GRIPS to both ends of the CARRIAGE as shown in (DETAIL ~B) using
the follo~fng steps:
Thoroughly clean all surfaces where the PARAGLIDE
STRIPS are to be attached.
¯
Remove the PAP,_AGL]]3E STP~S from the paper backing and fu-mly apply them to all shown
surfaces.
6.
Insert one (1) 1-3/4 IN. SQ. END CAP into the CARRIAGE UPRIGHT as shown on drawing.
Slide the C.M~RL~GE onto the C.MhRIAGE UPRIGHT and SECURELY attach
the CARRIAGE
UPRIGHT to the BASE, using two (2) 3/8 x 3 IN. BOLTS, one, (1) 3/8 x 2-3/4 IN. BOLT, six (6)
IN. WASHERS. and three (3) 3/8 IN. LOCK NUTS.
PART #6656601
4
REVISION 10/21/96
Advertisement
