Functions Added In Version 3.0; Functions Added In Version 3.1 - Omron ns series Operation Manual

1-1 Overview and Features
1-1-6 Functions Added in Version 2.9
• The NS-series PT does not have to be restarted when starting or stopping the
• The Ladder Monitor can be started from user screens (with NS system version 6.6
• The Controller Section of an NSJ Controller can be monitored (Controller host).
• Support has been added for the new CS/CJ-series string Instructions and SFC
1-1-6 Functions Added in Version 2.9
The following functions have been added for Ladder Monitor version 2.9.
• Scrolling buttons have been added (ScrUp and ScrDown).
• Program section in which two or more wraps occur can now be displayed.
• The following instructions, which were added for the CJ1H-H-R, are now supported:
1-1-7

Functions Added in Version 3.0

The following functions have been added for Ladder Monitor version 3.0.
• With NS system version 8.0 or higher, the places where an address that is specified
• I/O comments can be read from a symbol table stored in the PLC, so I/O comment
• I/O comments can be displayed in one or three lines, or not at all.
• Step searches, address searches, and output instruction searches are all supported
• It is possible to return to a maximum of 30 previously searched program sections.
• The cursor is now displayed in the program section. The communications address
• Timer and counter set values can be changed.
• The maximum numbers of rows and columns that can be displayed on a screen
• The maximum number of communications addresses that can be registered to the
• Communications addresses registered to the Multiple I/O Monitor are remembered
• The Ladder Monitor is started in I/O Monitoring Mode, and it can be exited while
• Ladder Monitor screens can be captured and saved to a Memory Card as bit map
20
PTs and NSJ Controllers with system version 6.6 or higher (except for the NS5-V2
and NSJ5).
Ladder Monitor (with NS system version 6.6 or higher).
or higher).
instructions.
SINQ, COSQ, TANQ, MOVF, TIMU, TIMUX, TMUH, TMUHX, and FIORF
as an alarm is used can be automatically found by starting the Ladder Monitor from
the Alarm/Event Summary and History on the PT screen.
files no longer have to be created in advance using the I/O Comment Extracting
Tool.
to provide for different applications. It is also possible to search for input conditions
that use output communications addresses.
at the cursor position can be searched and the present value can be changed.
have been increased. Up to 13 rows and 13 columns can be displayed for the
NS10/8, or 17 rows and 16 columns for the NS12, when I/O comments and the
Multiple I/O Monitor are not both displayed.
Multiple I/O Monitor has been increased to 16 for the NS12 and 12 for the NS10/8.
even after exiting the Ladder Monitor, so the same communications addresses can
be monitored when the Ladder Monitor is next started.
executing I/O monitoring or multiple I/O monitoring.
files.