Omron ns series Operation Manual page 34

2-1 Starting the Ladder Monitor
Starting the Ladder Monitor
There are three methods that can be used to start the Ladder Monitor.
1. Select Ladder Monitor from the Special Screen of the PT System Menu
2. Start the Ladder Monitor from a user screen.
• Set $SW0 to 4036 from a user screen.
• Press a Multifunction Object set for the Ladder Monitor.
3. Start the Ladder Monitor from the Alarm/Event Summary and History on a user
screen.
• The Ladder Monitor can be started from user screens when using an NS-series PT
Note
with system version 6.6 or higher and Ladder Monitor version 2.8 or higher.
• With NS-series PT system version 8.0 or higher, addresses set as alarms/events are
searched for automatically when the Ladder Monitor is started if alarms/events are
selected in the Alarm/Event Summary and History.
Starting the Ladder Monitor from the System Menu
1. Turn ON the power to the PT and use one of the following methods after the PT enters
RUN mode to display the System Menu.
• NS15
Press one of the four corners of the touch panel twice in a row.
• NS12/10/8
Press two of the four corners of the PT touch panel simultaneously.
2. Press the Special Screen Tab.
32
Press one corner
twice in a row.
Exit
Special
Screen
Alarm Hist.(Sort by Occurr.) System Version
Alarm Hist.(Sort by Freq.)
Special Function
Device Monitor
Operation Log (Sort by Occurr.)
Comm.Test
Ladder Monitor
Operation Log (Sort by Freq.)
Error Log (Sort by Occurr.)
START
Error Log (Sort by Freq.)