Omron ns series Operation Manual page 46

3-1 Main Screen
3-1-1 Ladder Display Area
Note 3: Displaying Block Programming Areas
Note 4: Displaying Rung Comments, Comment Boxes, and Rung Annotations
Note 5: Displaying Function Blocks
44
section break (-[SECTION]) is displayed on the divided part in the middle of the program
section as shown below.
0000. 0000.0 0000.0 0000. 0000.
03 04
00 1 2
SW1 SW2 SW3 SW4 SW5
0000. 0000.1 0000.1 0000. 0000.
09 0 1 12 13
SW10 SW11 SW12 SW13 SW14
When using block programming, "----[BPRG]" is displayed with the block number at the
beginning of the block programming area. The mnemonics inside of the block programming
area are not displayed. The programming can be displayed using ladder diagrams.
However, if the program contains instruction that cannot be displayed in a ladder diagram,
the message "This program section cannot be shown " will appear. "---- [BEND]" is
displayed at the end of block program.
0000.00 0000.01
SW1 SW2
Rung comments, comment boxes, are rung annotations created on the CX-Programmer
cannot be displayed.
A function block is displayed as ---[FB].
0000. 0000. 0000. 0000. 0100.0
05 06 07
08 0
SW6 SW7 SW8 SW9
LAMP
[SECTION]
0000. 0000. 0001. 0001. 0100.0
14 15 00 01 1
SW15 SW16 SW17 SW18
LAMP
Shows the
split of the
section.
Indicates block
[BPRG]
programming
area.
[
BEND]