NETGEAR DM200 User Manual page 14

Broadband High-Speed DSL Modem Model DM200
To connect your modem to a DSL service:
1. Install an ADSL or DSL microfilter between the phone line and the phone.
The product package contains either an ADSL or DSL microfilter.
2. Use a phone cable to connect the microfilter to the gray DSL port on the modem.
The product package contains a phone cable.
3. Connect the power adapter to the modem and plug it into an electrical outlet.
Wait for the Power LED
4. If the Power LED does not light, press the Power On/Off button.
5. Check the DSL LED
If the modem is connected to a DSL service, the DSL LED lights green.
6. Use an Ethernet cable to connect your computer to the yellow Ethernet LAN port on the modem.
The product package contains a yellow Ethernet cable.
Your computer connects to the modem's LAN.
Note If the computer is set to a static (fixed) IP address (this setting is uncommon), either
change the computer to obtain an IP address automatically from the modem through
DHCP, or change the IP address of the computer to a static IP address in the
192.168.5.2–192.168.5.254 range.
7. Launch a web browser.
to light solid green, which takes about one minute.
.
Install and Access the Modem
14