NOTE:
The S5120-28C-EI, S5120-52C-EI, S5120-28C-PWR-EI, and S5120-52C-PWR-EI support IRF. For more
information, see
Installing the switch into a 19-inch rack
Installation methods
You can install a switch into a 19-inch standard rack in one of the following ways:
Use front mounting brackets
•
Use front mounting brackets and a rack-shelf
•
•
Use front mounting brackets and rear mounting brackets
The installation methods of a switch depend on the depth of the switch. For the specific installation
methods, see
Table 3 Installation methods
Method
Depth
300 mm (11.81 in)
420 mm (16.54 in)
NOTE:
For a switch with a depth greater than 300 mm (11.81 in), the front mounting brackets only secure the
switch rather than bear its weight.
Mounting bracket
Figure 2 Appearance of a standard front mounting bracket
(1) Screw hole for attaching the mounting bracket to the cabinet (Use one M6 screw)
(2) Screw hole for attaching the switch to the mounting bracket
"Setting up an IRF
fabric."
Table
3.
Use front mounting
brackets
√
N/A
Use front mounting
brackets and a rack-shelf
√
√
5
Use front and rear
mounting brackets
N/A
√