Preparing for installation
Safety recommendations
To avoid any equipment damage or bodily injury caused by improper use, observe these rules:
Before cleaning the switch, remove the power cord of the switch. Do not clean the switch with wet
•
cloth or liquid.
Do not place the switch near water or in a damp environment. Prevent water or moisture from
•
entering the switch chassis.
Do not place the switch on an unstable case or desk. The switch might be severely damaged in case
•
of a fall.
Ensure proper ventilation of the equipment room and keep the ventilation vents of the switch free of
•
obstruction.
•
Make sure the operating voltage is as required.
To avoid electrical shocks, do not open the chassis when the switch is operating or when the switch
•
is just powered off.
When replacing interface cards, wear an ESD-preventive wrist strap to avoid damaging the cards.
•
Examining the installation site
The S5120-EI Switch Series must be used indoors. You can mount your switch in a rack or on a workbench,
but make sure:
•
Adequate clearance is reserved at the air inlet and exhaust vents for ventilation.
The rack or workbench has a good ventilation system.
•
The rack is sturdy enough to support the device and its accessories.
•
The rack or workbench is well earthed.
•
To ensure normal operation and long service life of your switch, install it in an environment that meets the
requirements described in the following subsections.
Temperature/humidity
Maintain temperature and humidity in the equipment room as described in
Lasting high relative humidity can cause poor insulation, electricity creepage, mechanical property
•
change of materials, and metal corrosion.
Lasting low relative humidity can cause washer contraction and ESD and bring problems including
•
loose captive screws and circuit failure.
High temperature can accelerate the aging of insulation materials and significantly lower the
•
reliability and lifespan of the switch.
1
"Technical
specifications."