S5120-52C-Pwr-Ei - H3C S5120-EI series Installation Manual

Figure 46 S5120-28C-PWR-EI (PoE+ model) fear panel
(1) RPS power input
(3) Grounding screw
(5) Interface card slot 2 (MOD2)
Figure 47 S5120-28C-PWR-EI (PoE model) rear panel
(1) RPS power input
(3) Grounding screw
(5) Interface card slot 2 (MOD2)
NOTE:
The S5120-28C-PWR-EI is shipped with the two expansion interface card slots covered by filler panels.
You can select one or two interface cards for your switch as needed. For the interface cards available for
the S5120-EI Switch Series, see
removing an interface

S5120-52C-PWR-EI

S5120-52C-PWR-EI includes two models: PoE and PoE+.
• The front panels of the PoE and PoE+ models are the same in appearance. See
The PoE+ model has a PoE+ label on its rear panel, as shown in
•
per port is 30 W.
The PoE model has no PoE+ label on its rear panel, as shown in
•
per port is 15.4 W.
For more information about the PoE power supply, see
"Interface cards." For how to install an interface card, see
card."
38
(2) AC power input
(4) Interface card slot 1 (MOD1)
(6) PoE+ label
(2) AC power input
(4) Interface card slot 1 (MOD1)
Figure 49. The maximum PoE power
Figure 50. The maximum PoE power
Table 8.
"Installing and
Figure 48.