Rack-Mounting By Using Front Mounting Brackets - H3C S5120-EI series Installation Manual

Figure 3 Appearance of a rear mounting bracket
(1) Screw hole for attaching the mounting bracket to the cabinet (Use one M6 screw)
For the selection of front and rear mounting brackets, see
Table 4 Selection of mounting bracket for the S5120-EI Switch Series
Model
S5120-28C-EI
S5120-52C-EI
S5120-24P-EI
S5120-48P-EI
S5120-28C-PWR-EI
S5120-52C-PWR-EI

Rack-mounting by using front mounting brackets

Only the S5120-28C-EI, S5120-52C-EI, S5120-24P-EI, and S5120-48P-EI support installation by using
front mounting brackets.
To mount a switch into a 19-inch standard cabinet:
1. Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded.
2. Verify the grounding and stability of the rack.
3. Unpack the screws which are packed together with the front mounting brackets, and attach one
end of mounting brackets to the switch, as shown in
Dimensions (H × W × D)
43.6 × 440 × 300 mm
(1.72 × 17.32 × 11.81 in)
43.6 × 440 × 420 mm
(1.72 × 17.32 × 16.54 in)
6
Table 4.
Configuration type of
front mounting bracket
Standard
Standard
Figure 4.
Configuration type of
rear mounting bracket
N/A
Standard