Applying Power - Konica Minolta DRYPRO SIGMA Installation Manual

Applying power

A countdown to zero (0) indicates
how soon the laser imager will be
ready to print
Inserting a film cartridge
2015-04-17
1.
Check that the film supply is closed.
2.
To start the laser imager, press the power switch on the back of the
laser imager to on (|). Wait as the laser imager warms up. The
warm-up period might last up to 30 minutes. The display screen
shows the progress as the laser imager becomes ready to print.
Warming up
The warm-up period varies depending on how long the laser imager
has been off and the ambient temperature.
NOTE: If the laser imager does not start, see
12.
1.
Open the film supply.
2.
Insert the film cartridge. Align the cartridge with the label facing up
and the perforations to the front. Set the leading edge on the
cartridge guides, then slide the film cartridge into the laser imager to
engage the detents in the bottom of the cartridge.
Cartridge
Guide
Perforations
Detents
3.
Close the film supply.
4.
Check that the film count appears on the display screen.
NOTE: If a film count does not appear, see the Operation Manual for
help.
9G7567_en
The power symbol is
yellow and flashing
while the laser
imager warms up
"Troubleshooting" on page
Leading Edge
H210_1020ACA
H210_1020AC
Film Supply
7