Understanding The Display Screen - Konica Minolta DRYPRO SIGMA Installation Manual

Basic Operating Tasks

Understanding the Display Screen

The display screen communicates the status of the imager.
Symbol or code
Top left of the
display screen:
Lower left of
the display
screen:
Power
Calibrate
Pause
Film Size
2–2
Description
Error or status code. The 3-digit code displays when the error or status con-
dition is present. If the imager is on and a 3-digit code does not display, the
imager is operating normally.
If a different film size has been requested than what is installed, the
requested film size displays.
When the imager is starting, a countdown displays the number of minutes
until the imager will be ready to print (for example, -4 means 4 minutes
until the imager will be ready to print).
Film count. Displays the number of films that are remaining in the film car-
tridge.
The loaded film size also displays in this location.
If a blue number does not display while the imager is powered on, the film
cartridge is not inserted (or not fully inserted) into the imager.
When the symbol is green, the power is on and the imager is ready to print.
The symbol flashes while the imager is while processing, calibrating, or
making a test print.
When the symbol is yellow, the imager is not ready to print. Examples are
when the imager is warming up or when the film cartridge is empty.
Press to initiate film calibration. The symbol flashes while the calibration is
in process.
Calibration might be needed if the symbol is on and code 624, 631, or 632
appears.
During normal operation, the symbol is off. (See exceptions in the note
below.) When the film cartridge cover is open, the symbol is on. To avoid
exposing the film to light, do not open the film supply until the symbol is
off.
If the Pause symbol is on, you can press the symbol to temporarily pause
printing. Any jobs in progress finish printing, then the film cartridge cover
closes.
Wait until the Pause symbol is off for cartridge replacement, etc.
Note
The Pause symbol is on while the imager is processing images or test prints
and during calibration.
When the symbol appears, the requested job requires a different film size.
You can also cancel all pending print jobs that require an unavailable media
size.
9G7564_en | 2013-04-01