Load A Different Film Size To Match A Print Request - Konica Minolta DRYPRO SIGMA Installation Manual

Basic Operating Tasks

Load a Different Film Size to Match a Print Request

If a print request requires a different film size, the requested film size flashes on the
display screen. Change the installed film to match the print request.
Figure 7: The requested film size (in this example, "35" and then "43") flashes. The Film Size
symbol indicates that you must change the film size. In this example, load 35 x 43 cm
(14 x 17 in.) film. In most cases, the Pause symbol is off. Do not open the film supply if the Pause
symbol is on. The Pause symbol indicates that the film cartridge is open.
1. If the Pause symbol is on, press it and wait until it turns off.
2. Open the film supply.
3. Hold the edges of the film cartridge and lift the cartridge out of the film supply.
4. Store the removed film cartridge.
5. Insert the new film cartridge:
a. Align the cartridge with the label facing up and the perforations (1) to the front.
b. Set the leading edge (2) on the cartridge guides (3).
c. Slide the film cartridge into the imager to engage the detents (4) in the bottom
of the cartridge.
6. Close the film supply (5).
7. Check that the display screen changes to reflect the new film size.
2–8 9G7564_en | 2013-04-01