Section 2: Setting The Relay Using Reydisp Evolution; Physical Connection; Front Usb Connection - Siemens 7SR224 Technical Manual

Section 2: Setting the Relay Using Reydisp Evolution

To set the relay using the communication port the user will need the following:-
PC with Reydisp Evolution Installed. (This can be download from our website
found under the submenu 'Software')This software requires windows 2000-service pack 4 or above, or windows
XP with service pack 2 or above.
2.1

Physical Connection

The relay can be connected to Reydisp via any of the communication ports on the relay. Suitable communication
Interface cable and converters are required depending which port is being used.
2.1.1

Front USB connection

To connect your pc locally via the front USB port.
Local
Engineer
Access
©2010 Siemens Protection Devices Limited
7SR224 Argus Settings, Configuration & Instruments
USB Type A
Socket on PC
USB Type A
Figure 2.1.1-1 USB connection to PC
www.siemens.com/energy
Female socket on
USB Type B Male
USB Data Cable
Chapter 2 Page 9 of 13
and
USB Type B
Relay