BMW S 1000RR Owner's Manual page 32

source on the motorcycle
3
failing.
Safety risk
30
Replace defective bulbs as
soon as possible; it is best
always to carry a complete
set of spare bulbs on the
motorcycle.
Possible cause:
Turn indicator bulb defective
Replacing front and rear turn
z
indicator bulbs (
Possible cause:
The license-plate carrier is re-
moved and the vehicle's elec-
tronic monitoring system detects
the missing turn signals.
Install license-plate carrier
( 99).
Activating suppression of the
fault message in the
mode.
Motorcycle has fallen over
! VDS
shown in the empty display.
Possible cause:
The fall sensor has detected a
fall and switched off the engine.
Position motorcycle upright.
Switch ignition off and then on
again or switch emergency ON/
OFF switch on and then off
again.
144).
Fall sensor defective
! VDS
shown.
Possible cause:
A defect was determined in the
fall sensor.
Contact an authorized service
facility, preferably an authorized
BMW Motorrad retailer.
SETUP
(Vertical Down Sensor) is
(Vertical Down Sensor) is
ABS self-diagnosis not
completed
ABS indicator light flashes.
Possible cause:
The ABS function is not avail-
able, because the self-diagno-
sis has not been completed. To
check the wheel sensors, the
motorcycle must be driven a few
yards.
Ride off slowly. It must be
noted that the ABS function
is not available until the self-
diagnosis has been completed.
ABS deactivated
ABS indicator light lights
up.
Possible cause:
The ABS system has been deac-
tivated by the driver.
Switch on ABS function
( 44).