Table of Contents
Advertisement
2. Insert the supplied three Anchors into the three holes and then screw the Base Plate to the
ceiling / desk using the supplied three Screws.
3. Place the Spacer onto the rear side of the camera. Remove the cut-out from the Spacer only if
you want to run the cables along the ceiling / desk.
4. Optionally insert the micro SDHC / SDXC card to the push-pull type SD card slot on the rear side
of the camera.
Rear side of the camera
Base Plate
Spacer
Push
7
EFN Series Fisheye IP Camera
Pull
Advertisement
Table of Contents
