Table of Contents
Advertisement
3. If you are using the Base Plate, place the Spacer onto the rear side of the camera. This step is
only for the Base Plate mounting. Remove the cut-out from the Spacer only if you want to run
the cables along the wall.
4. Optionally insert the micro SDHC / SDXC card to the push-pull type SD card slot on the rear side
of the camera.
Rear side of the camera
5. Align the three latches on the camera with the three holes on the Base Plate / Tilting Wall
Mount Bracket, attach the camera to the Base Plate / Tilting Wall Mount Bracket and then
rotate clockwise to secure the camera to the Base Plate / Tilting Wall Mount Bracket.
With Base Plate
Spacer
Push
With Tilting Wall Mount Bracket
10
EFN Series Fisheye IP Camera
Pull
Advertisement
Table of Contents
