Table of Contents
Advertisement
1. Stick the Mounting Template to the wall. Drill the three red cross marks on the inner circle. If
you want to use the supplied Tilting Wall Mount Bracket, drill the three black cross marks on
the outer circle. Drill the square below only if you wish to run the cables through the wall. Note
that the square below also indicates the cable position. Point the square below to the direction
for running the cables.
For the Tilting Wall Mount Bracket
2. Insert the supplied three Anchors into the three holes and then screw the Base Plate / Tilting
Wall Mount Bracket to the wall using the supplied three Screws.
Base Plate
Drill a hole only if you want to
run the cables through the wall.
Toward the ground
Tilting Wall Mount Bracket
9
EFN Series Fisheye IP Camera
Advertisement
Table of Contents
