• Do the following settings after installing a "new" EEPROM.
-Input the PnP Name, Destination in Maintenance mode.
-Adjust the Registration in Maintenance mode.
-Input serial number on the serial number input display after installing the new EEPROM
• Ask your supervisor about how to access the serial number input display.
Controller Board
• Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to
the instructions.
1. ECB (
p.93 "ECB (Engine Controller Board)")
2. Controller board [A] ( x 4, flat cable x 1, all
FCU
1. ECB (
p.93 "ECB (Engine Controller Board)")
2. Controller board(
p.95)
s)
Electrical Components
95