Light Emitting Diodes (Led) On Battery - Stihl MSA 160 T Instruction Manual

English
3 4
The LED (3) on the charger comes on
when the battery is inserted – see "LED
on Charger"
Charging begins as soon as the
LEDs (4) on the battery glow green –
see "LEDs on Battery".
The charge time is dependent on a
number of factors, including battery
condition, ambient temperature, etc.,
and may therefore vary from the times
specified.
The battery heats up during operation in
the power tool. If a hot battery is inserted
in the charger, it may be necessary to
cool it down before charging. The
charging process begins only after the
battery has cooled down. The time
required for cooling may prolong the
charge time.
The battery and charger heat up during
the charging process.
AL 300, AL 500 Chargers
The AL 300 and AL 500 chargers are
equipped with a battery cooling fan
60
AL 100 Charger
The AL 100 charger has no fan and
waits for the battery to cool down before
starting the charging process. The
battery is cooled by heat transfer to the
ambient air.
End of Charge
The charger switches itself off
automatically when the battery is fully
charged:
LEDs on the battery go off.
–
The LED on the charger goes off.
–
The charger's fan is switched off (if
–
charger is so equipped)
Remove the fully charged battery from
the charger.
Light Emitting Diodes (LED)
on Battery
Four LEDs show the battery's state of
charge and any problems that occur on
the battery or power tool.
1
Press button (1) to activate the
N
display – the display goes off
automatically after 5 seconds.
The LEDs can glow or flash green or
red.
LED glows continuously green.
LED flashes green.
LED glows continuously red.
LED flashes red.
MSA 160 T